|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Design and construction
The ABC was built by Dr. Atanasoff and graduate student Clifford Berry in the basement of the physics building at Iowa State College during 1939–42. The initial funds were released in September, and the 11-tube prototype was first demonstrated in October, 1939. A December demonstration prompted a grant for construction of the full-scale machine.[3] The ABC was built and tested over the next two years. It was described in a January 15, 1941 notice in the Des Moines Register. The system weighed more than seven hundred pounds (320 kg). It contained approximately 1 mile (1.6 km) of wire, 280 dual-triode vacuum tubes, 31 thyratrons, and was about the size of a desk. It was not a Turing complete computer, which distinguishes it from more general machines, like contemporary Konrad Zuse's Z3 (1941), or later machines like the 1946 ENIAC, 1949 EDVAC, the University of Manchester designs, or Alan Turing's post-War designs at NPL and elsewhere. Nor did it implement the stored program architecture that made practical fully general-purpose, reprogrammable computers. The machine was, however, the first to implement three critical ideas that are still part of every modern computer:
The memory of the Atanasoff-Berry Computer was a pair of drums, each containing 1600 capacitors that rotated on a common shaft once per second. The capacitors on each drum were organized into 32 "bands" of 50 (30 active bands and 2 spares in case a capacitor failed), giving the machine a speed of 30 additions/subtractions per second. Data was represented as 50-bit binary fixed point numbers. The electronics of the memory and arithmetic units could store and operate on 60 such numbers at a time (3000 bits). The AC power line frequency of 60 Hz was the primary clock rate for the lowest level operations. The arithmetic logic functions were fully electronic, implemented with vacuum tubes. The family of logic gates ranged from inverters to two and three input gates. The input and output levels and operating voltages were compatible between the different gates. Each gate consisted of one inverting vacuum tube amplifier, preceded by a resistor divider input network that defined the logical function. The control logic functions, which only needed to operate once per drum rotation and therefore did not require electronic speed, were electromechanical, implemented with relays. Although the Atanasoff-Berry Computer was an important step up from earlier calculating machines, it was not able to run entirely automatically through an entire problem. An operator was needed to operate the control switches to set up its functions, much the way boot programs would be entered in later computers. Selection of the operation to be performed, reading, writing, converting to or from binary to decimal, or reducing a set of equations was made by front panel switches and in some cases jumpers. There were two forms of input and output. Primary user input and output and an intermediate results output and input. The intermediate results storage allowed operation on problems too large to be handled entirely within the electronic memory. (The largest problem that could be solved without the use of the intermediate output and input was two simultaneous equations, a trivial problem.) Intermediate results were written onto paper sheets by electrostatically modifying the resistance at 1500 locations to represent 30 of the 50 bit numbers (one equation). Each sheet could be written or read in one second. The reliability of the system was limited to about 1 error in 100,000 calculations by these units, primarily attributed to lack of control of the sheets' material characteristics. In retrospect a solution could have been to add a parity bit to each number as written. This problem was not solved by the time Atanasoff left the university for war-related work. Primary user input was via standard punched cards and output via a front panel display. Comparison with other early computers
FunctionThe ABC was designed for a specific purpose, the solution of systems of simultaneous linear equations. It could handle systems with up to twenty-nine equations, a difficult problem for the time. Problems of this scale were becoming common in physics, the department in which John Atanasoff worked. The machine could be fed two linear equations with up to twenty-nine variables and a constant term and eliminate one of the variables. This process would be repeated manually for each of the equations, which would result in a system of equations with one fewer variables. Then the whole process would be repeated to eliminate another variable. ControversyJ. Presper Eckert and John Mauchly were the first to patent a digital computing device, the ENIAC. The ABC had been examined by John Mauchly in June 1941, and Isaac Auerbach, a former student of Mauchly's, alleged that it influenced his later work on ENIAC, although Mauchly denied this (Shurkin, pg. 280-299). In 1967 Honeywell sued Sperry Rand in an attempt to break their ENIAC patents, and claiming the ABC as prior art. The United States District Court for the District of Minnesota released its judgement on October 19, 1973, finding in Honeywell v. Sperry Rand that the ENIAC patent was a derivative of John Atanasoff's invention. The decision was not appealed. Atanasoff, however, never considered himself to be the originator of the idea of a general purpose computer until years after the ENIAC was revealed. In 1954 a patent attorney from IBM approached Atanasoff asking for his help in breaking the Mauchly patent. In a 1982 interview with Shurkin, Atanasoff said "That was the first shock I had. First time. Nobody had compared the two of us." Campbell-Kelly and Aspray conclude:
ReplicaThe original ABC was eventually dismantled, when the University converted the basement to classrooms, and all of its pieces except for one memory drum were discarded. In 1997, a team of researchers from Ames Laboratory (located on the Iowa State campus) finished building a working replica of the Atanasoff-Berry Computer for a cost of $350,000. This replica dispelled any doubt over whether or not the ABC actually could perform the tasks it was designed to do. The new ABC is now on permanent display in the first floor lobby of the Durham Center for Computation and Communication at Iowa State University. See alsoReferences
|
Sites |
Searched sites for "Atanasoff-Berry Computer" |
|
No sites found. |
Sorry, no matching site records were found. |
Want your site listed here?
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Submit
your site |
|
Relevant quality search results and fast easy navigation throughout the
different sections of the site, make Americola.com |